Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Line the inside of the curve with kitchen foil or aluminium tape, then stand the router's antenna up through the hole at the focus. Prints as shown on its outline, no supports.
Lay the charging cable through the back port to the glasses' hinge connector. Prints as shown on its floor, no supports.
The phone stands inside on its side, filling the screen; the cable leaves through the back. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in coral or purple; each curling arm holds one cable end. Prints as shown on its outline, no supports.
The slot fits handhelds up to 30 mm thick; feed the USB-C cable up through the back port. Prints as shown on its floor, no supports.
Feed a cable up through each back port; a 3-port USB charger fits behind it. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a paper-coloured matt PLA; the slot side is the top. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
PETG or TPU; print a set with different words. Prints flat as a plate, no supports.
Print upright in PLA or PETG. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print it lying on its flat underside, in PETG or TPU. Prints as shown on its outline, no supports.