Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Hold a charging phone on a shelf that hangs from its own charger plug
A phone charging from a low socket ends up on the floor, dangling or tripping someone up. This shelf needs no screws: the plug-in charger sits inside it, pins out through the hole in the back, and when you plug it in, the charger itself holds the shelf flat against the wall below the switch. The phone stands in the front, its cable coiled out of sight behind it. It works with UK, European and US two-pin and three-pin chargers.
Printing notes
11.7 cm³
Volume
14.5 g
Est. weight
1,656
Triangles
Push the charger's pins out through the back hole and plug it in: the charger holds the shelf against the wall. The phone stands in front. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
MAIN PURPOSE: Charge phones and tablets upright
Three upright bays for phones and tablets, with a cable hole at the back.
Printing notes
90.0 cm³
Volume
111.6 g
Est. weight
800
Triangles
Prints as shown on its floor, no supports.