Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Fits pencils up to 19 cm. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Melt beeswax with a little crayon or charcoal for colour and pour it 3 mm deep. Sharpen a chopstick to a point for the stylus. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print the pot and the turntable ring; drop a few ball bearings or a dab of grease between them for a smooth spin. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Slots fit styluses up to 12 mm thick; the side box takes spare nibs and the nib remover. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; PVA peels off it when dry. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print drawers in a darker colour for the kaidan look. Prints as shown on its floor, no supports. The 3 drawers print separately from the case.
Twelve 6 x 3 mm magnets, same polarity rule. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Line the roof tray before planting live sedum. Prints as shown on its floor, no supports. The 2 drawers print separately from the case. Stacked parts are fused into one print.
Print four; glue felt underneath. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print in PETG; plug metal shells need to be 7 mm long. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.