Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print three or four; 8 mm dowel. Prints as shown on its floor, no supports.
Print upright; push the dowel into the post. Prints as shown on its floor, no supports.
PETG or ASA for heat; print flat.
Print upright; tabs come out hollow. Prints as shown on its outline, no supports.
Print the lid separately, upside down. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Glue 16 x 6 x 3 mm magnets flush, polarity as described. Prints as shown on its floor, no supports.
Twelve 6 x 3 mm magnets, same polarity rule. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Twelve 6 x 3 mm magnets. Prints as shown on its floor, no supports.
Print flat in PETG, 2 mm; print six to ten.
Print as it comes (comb on the bed), solid; fix with foam tape.