Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print flat; the peg prints upright, a touch of support under the cap. Stacked parts are fused into one print.
Print floor down. Prints as shown on its floor, no supports.
Print eight flat in PETG; twelve M4 bolts and nylock nuts. Prints flat as a plate, no supports.
Print 24 flat in PETG; 36 M3 screws and nylock nuts. Prints flat as a plate, no supports.
Print 20 to 30 flat; an 8 mm dowel 200 mm long. Prints flat as a plate, no supports.
Print six flat in PETG. Prints flat as a plate, no supports.
Print upright, 4 walls for a stiff stem. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print six; 10 mm ribbon and craft glue. Prints as shown on its floor, no supports.
Print twelve flat; two M3 bolts. LED lights only. Prints flat as a plate, no supports.
Print four flat in PETG; M4 bolts, nylock nuts, a pencil. Prints flat as a plate, no supports.