Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Thread two hook-and-loop straps through the side slots round the rollator seat frame. Prints as shown on its floor, no supports.
Pockets fit standard elongated cents up to 33 x 20 mm; print more trays and stack them. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Hang through the keyholes; each ledge takes about six thimbles. Prints as shown on its floor, no supports.
Pack cotton wool with petroleum jelly as tinder; the twist-lock lid keeps it dry. Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Food-safe PETG; the lid turns over into a flat serving board. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food-safe PETG; not for boiling water. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Wire coils sit on their sides in the round cups so they don't tangle. Prints as shown on its floor, no supports.
Slots fit styluses up to 12 mm thick; the side box takes spare nibs and the nib remover. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print two in TPU or PETG; scale the length to the blade. Prints as shown on its floor, no supports.
Fits 2-inch net cups; float or rest it on a dark tub and top up only once. Prints as shown on its floor, no supports.