Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Holds six feather or nylon shuttles stacked nose-down. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in black with the lid crack in gold. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Tips rest in the chamber below; a damp paper towel in the base keeps them fresh. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in green or a marble filament for the shell. Prints as shown on its outline, no supports.
The quill shaft at the bottom is a handle for lifting it off the desk. Prints as shown on its outline, no supports.
Print in white or translucent filament; 0.4 mm walls show off the fractal edge. Prints as shown on its outline, no supports.
White PETG stays cooler in the car than black. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Keep the lid on between sessions so the slime doesn't dry out. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fits standard cash envelopes about 175 x 90 mm; label the bays with the front slot. Prints as shown on its floor, no supports.
Food-safe PETG; the two sides lift out for the dishwasher rack. Prints as shown on its floor, no supports.