Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Load a stack of flat shoe covers through the top; screw to the wall at shoe height. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Drop in three nursery pots up to 9 cm; give it a third of a turn every morning. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
PETG; hose it out after use. Prints as shown on its floor, no supports.
The long slot takes a 150 mm plexi scraper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
The ring cup fits gourds up to 80 mm across the base. Prints as shown on its floor, no supports. The added base's lid prints separately.
PETG; tip the drip tray out over a sink. Prints as shown on its floor, no supports.
Mount at adult height; wash the spacer as your nurse advises and let it dry in the tube. Prints as shown on its floor, no supports.
Holes fit 9 mm and 13 mm ink caps; wrap in barrier film as usual. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Hang at child height through the keyholes; darts stand nose-up in the rows. Prints as shown on its floor, no supports.
Use the screw lid when travelling; rinse the cup daily. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.