Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in purple for the classic T piece; it tessellates with other tetromino bins in a drawer. Prints as shown on its floor, no supports.
Print the lid in a speckled filament for a real egg look. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in PETG; the slots let the goggles drip dry in the bag. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; wash in warm soapy water, not the dishwasher. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Write the grain weights on the lid label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Put a sponge soaked in 1:4 sugar water in some petals and orange slices in others; refresh every two days. Prints as shown on its floor, no supports.
Bird-safe use: print in natural PLA, check for loose strings each week and remove if chewed sharp. Prints as shown on its floor, no supports.
Food contact: line the bays or use food-safe PETG and wash by hand. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Food-safe PETG; the lid keeps leftovers in the fridge in the same tray. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG or PP; water-based ink rinses straight off. Prints as shown on its floor, no supports.