Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Thread a 40 mm belt through the two back slots; PETG for mud and rain. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Mount on a post or fence through the keyholes; ASA or PETG outdoors. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Put it between two seats; a half turn swaps the sides. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Fits batons up to 290 mm with a 22 mm handle; print lying flat. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holes take 16 mm test tubes; the lower tray catches spills. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the tiers alternately red and white. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Food-safe PETG; keep it away from the window. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Print the hub white and the pods grey. Prints as shown on its floor, no supports.
Feed a cable up through each back port; a 3-port USB charger fits behind it. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Keep a separate scoop in each bay; one stray coarse grain scratches a whole polish batch. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.