Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Scoop, shake over the sand, then move the keepers into the three side bays. Prints as shown on its floor, no supports.
Slide paper labels into the drawer-front slots. Prints as shown on its floor, no supports. The 4 drawers print separately from the case.
Read the notes together later, then tell your child the monster ate them. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Put it in the middle of the board-game table, one arm towards each seat. Prints as shown on its floor, no supports.
Print four, one per seat; the five slots take the bid cards from 1 to 7. Prints as shown on its floor, no supports.
Print the big oxygen cup red and the two hydrogen cups white, like a school model. Prints as shown on its floor, no supports.
Lay out the primaries at 12, 4 and 8 o'clock and mix the in-between wells. Prints as shown on its floor, no supports.
Print in a tan or brown; a long sausage dog fits a row of pens nose to tail. Prints as shown on its outline, no supports.
Print in a pale gold; the tilted ring ends make tidy cradles for single rings. Prints as shown on its outline, no supports.
Lay half black and half white paper in each bay, cap gills-down across the join, lid on overnight. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.