Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Rest the canvas on the raised inner ring; scrape the cured drips out of the moat and reuse them as paint skins. Prints as shown on its floor, no supports.
Glue a sheet of glass or acrylic in the slab bay for the smoothest roll-out. Prints as shown on its floor, no supports.
Fill through the base; tilt it and a marker drops out of the top hole. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Match cloth colours to the coloured words: blue glass, red bathroom, green kitchen, yellow dusting. Prints as shown on its floor, no supports.
The perforated floor lets sand fall out; PETG copes with a hot car. Prints as shown on its floor, no supports.
Weight the base with a few coins if your wands are long. Prints as shown on its floor, no supports. The added base's lid prints separately.
Lay damp paper towel in each lane with 10 seeds, lid on, and count the sprouts after a week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in coral or purple; each curling arm holds one cable end. Prints as shown on its outline, no supports.
Print in red or green with the word in gold; envelopes stand in three rows. Prints as shown on its floor, no supports.
The tube takes three rolled overgrips; dampeners go in the small bays. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added base's lid prints separately.