Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Wrap the post in mirror film; draw on a printed polar grid laid on the board. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Fits 12.7 x 28 cm pop-up foils; screw it to the trolley through the keyholes. Prints as shown on its floor, no supports.
Cups fit boules up to 76 mm; the centre box holds the jack and a measuring tape. Prints as shown on its floor, no supports.
Print the cover, turn it over the cheese; the flat lid is the board underneath. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
The cups take standard tape rolls; the box takes stick wax and a lace hook. Prints as shown on its floor, no supports.
The small screw-top keeps the needles; the tube takes pumps up to 32 mm. Prints as shown on its floor, no supports. The added base's lid prints separately.
Print in turquoise, gold or deep blue. Prints as shown on its outline, no supports.
Print two, one dark and one light, and turn one round so they lock into a circle. Prints as shown on its outline, no supports.
Seen from above, the three bays make the classic tumbling-block cube illusion; paint them three shades. Prints as shown on its floor, no supports.
Charm stems push into the floor holes; hang it through the keyholes or stand it on a shelf. Prints as shown on its floor, no supports.