Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Slots take standard graded slabs about 7 mm thick. Prints as shown on its floor, no supports.
The round pot holds styptic powder in case a nail bleeds. Prints as shown on its floor, no supports.
Brush both walls with release oil, pour fine concrete into the gap, cure 48 hours, then flex the mould off. Prints as shown on its floor, no supports.
The lid keeps the sand soft between sessions; the side garage holds moulds and tools. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in white; each bay's name is in the matching colour. Prints as shown on its floor, no supports.
Drop toy bones in, pour plaster with a little sand, leave 24 hours, then lift the block out by the lid and dig with a brush. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
The long side slot takes a pencil and a mini spirit level. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Mount with keyholes on screws or stick-on hooks; the slotted floor drains. Prints as shown on its floor, no supports.
Rows fit floats up to 280 mm; wrap the delicate tips in foam if you like. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Magnets go in the right-hand bay away from the pins, so they don't clump together. Prints as shown on its floor, no supports.