Models Showcase

Print in a bold colour; the loops make natural pockets for keys and coins. Prints as shown on its outline, no supports.

Drop 7 cm nursery pots into the bays; the back row sits higher so every flower shows. Prints as shown on its floor, no supports.

ASA or PETG; lay it with the hood facing away from the weather and run the cords through the side ports. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.

Lay coated paper on the floor, leaves on top, then a 2 mm glass sheet on the ledges; expose 10-15 minutes in sun. Prints as shown on its floor, no supports.

Print in white with the letters filled in black, or in black with white letters. Prints as shown on its floor, no supports.

Each bay fits a 75 mm mooncake; print in red or gold and line with paper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

The round well fits a jebena base up to 105 mm; food-safe PETG. Prints as shown on its floor, no supports.

Stand hackle and pheasant tail feathers in the tall box, quill-down. Prints as shown on its floor, no supports.

The big bay takes most smart-ring charging docks; the cable leaves through the back. Prints as shown on its floor, no supports.

Screw or tape it to the enclosure side; the slot takes scrapers up to 8 mm thick. Prints as shown on its floor, no supports.