Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in concrete grey with a rust-red water tower. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Translucent or glitter PETG; print upright with no supports. Prints as shown on its floor, no supports.
Prism in silk gold or silver; plinth in black. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flange up at 0.12 mm layers; scale 1 % if the fit is tight. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PLA at 3 walls; braces support the soundboard. Tine kit not included. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in black with gold text paint. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in PETG and pour the wax at 70 C or below. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.