Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print face down; print six or nine for a screen. Prints as shown on its floor, no supports.
One block per year, in a new colour each time. Glue in 10 x 3 mm magnets. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Pause at each terrace for a colour change: dark base to white summit. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a stone grey. Silica gel sachets keep seeds dry. Prints as shown on its floor, no supports. The 3 drawers print separately from the case.
Print the dish as one piece; a darker colour shows the points best. Prints as shown on its outline, no supports.
Print two, one for each city, in matching colours. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a soft pastel; matte PLA shows the engraving. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print open end up, then stand it on its open end. Print floor-down as shown, then turn it over to use it.
Print upright. Holds a portrait postcard (105 x 148). Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in dark blue or black so the lit stars stand out. Prints as shown on its floor, no supports.