Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Check with a reptile vet first. Use a fridge kept only for this, with a thermometer, and weigh the tortoise every week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Use with guidance from a physiotherapist or occupational therapist. A 290 x 125 mm sheet of 3 mm acrylic mirror slides into the centre slot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Fill with a handful of 4.5 mm steel BBs (or dry lentils for a softer sound), then screw the lid on. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
PETG. Let the dog watch you load it the first few times; supervise and put it away after play. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in white so the grid shows. Use 50 ml of liquid per bay and the same brand of bear in each. Prints as shown on its floor, no supports.
Fit a 60-100 mm magnifying lens over the front port, turn the phone image upside down, and lock its rotation; try each slot until the picture is sharp. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Glue two 30 mm, 5x lenses over the eye ports; print stereo pairs 63 mm apart on card and slip them in the back slot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print the sleeve and drawer in contrasting colours; the drawer pushes out from either end. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Cross three or four rubber bands through opposite wall holes to hang the egg in the cradle; tie a carrier-bag parachute to the lid ring. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Put each person's name peg or token in a bay; every Sunday give the turntable a quarter turn. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.