Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Add a pinch of calcium powder, drop in the crickets, cap it and shake gently. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in PLA; fill with dry sand and tape the lid shut. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PLA or PETG; line the trays with felt. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG resists oils better than PLA. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print lid and drum flat; a drop of glue on the thread once filled. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Keep away from children. Glue the strike strip to the cap top. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Thin walls resonate best: two perimeters, 10 % infill. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Uses the editor lazy-Susan base with BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Battery LED puck only. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print the lid face down for a smooth picture surface. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.