Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Write the grain weights on the lid label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Mount on a post or fence through the keyholes; ASA or PETG outdoors. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Put it between two seats; a half turn swaps the sides. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Fits batons up to 290 mm with a 22 mm handle; print lying flat. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Keep a separate scoop in each bay; one stray coarse grain scratches a whole polish batch. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Load a stack of flat shoe covers through the top; screw to the wall at shoe height. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
The long slot takes a 150 mm plexi scraper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Read the notes together later, then tell your child the monster ate them. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Lay half black and half white paper in each bay, cap gills-down across the join, lid on overnight. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holds six feather or nylon shuttles stacked nose-down. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.