Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The card stands in the slot on the stage; tuck a folded note under the lid. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
ASA or PETG; lay it with the hood facing away from the weather and run the cords through the side ports. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Weight the base with a few coins if your wands are long. Prints as shown on its floor, no supports. The added base's lid prints separately.
Lay damp paper towel in each lane with 10 seeds, lid on, and count the sprouts after a week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
The tube takes three rolled overgrips; dampeners go in the small bays. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added base's lid prints separately.
Needles go in the screw-top tube so they never end up in a toe pad. Prints as shown on its floor, no supports. The added base's lid prints separately.
Write the model and part numbers on the label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Thread a belt or the lead's waist strap through the back slots. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
The small screw-top keeps the needles; the tube takes pumps up to 32 mm. Prints as shown on its floor, no supports. The added base's lid prints separately.
The lid keeps the sand soft between sessions; the side garage holds moulds and tools. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.