Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in a pale gold; the tilted ring ends make tidy cradles for single rings. Prints as shown on its outline, no supports.
Tips rest in the chamber below; a damp paper towel in the base keeps them fresh. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in white or translucent filament; 0.4 mm walls show off the fractal edge. Prints as shown on its outline, no supports.
Write the perfume name at the bottom of each strip before you spray. Prints as shown on its floor, no supports.
Print three or four; 8 mm dowel. Prints as shown on its floor, no supports.
Print upright; push the dowel into the post. Prints as shown on its floor, no supports.
Print upright, open side up. Prints as shown on its outline, no supports.
PETG. Print flat.
Print in stone grey; core in a silk colour if you swap filament. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print upright; pause before the foot is closed to add sand for weight. Prints as shown on its outline, no supports. Stacked parts are fused into one print.