Drip Tip

Keep a soap bar dry and drain it off a leaf tip

A soap dish drawn from a rainforest leaf. Rainforest leaves end in a long drip tip that sheds water so the blade dries fast; here three short cross veins lift the bar off the floor, water runs round them into the narrow tip and drips out of the hole at its end. Set it on the basin rim with the tip over the bowl.

Customize this model

Size: 72 × 156 × 14 mm
Shape: Custom outline
Walls: 2.0 mm
Volume: 23.1 cm³
Est. weight (PLA): 28.6 g
Parts to print: 1
Category: Bath & body care
Made by: Krypto
Built in: 21 steps

What’s in it

Custom outline, 72 × 156 × 14 mm, with 2.0 mm walls
Custom outline traced from a shape
3 dividers
1 hole in the floor

How to print it

PETG. Print flat.

Filament: at most about 28.6 g of PLA printed solid (roughly $0.57 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the drip Tip model?

The drip Tip model measures 72 × 156 × 14 mm (width × depth × height). You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

Usually not. PETG. Print flat.

How much filament does it use?

At most about 28.6 g of PLA (23.1 cm³ printed solid), roughly $0.57 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.