Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG or ASA near the iron. Prints as shown on its floor, no supports.
Fill the race with 6 mm airsoft BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
PETG, printed flat. Prints flat as a plate, no supports.
PLA; uses 250 mm bamboo skewers. Prints as shown on its floor, no supports.
Print it lying on its side (the profile flat on the bed) in PETG.
Matt light filament shows the spot best. Marks set for about 51 degrees north. Prints as shown on its floor, no supports.
PETG resists oils better than PLA. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print lid and drum flat; a drop of glue on the thread once filled. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Keep away from children. Glue the strike strip to the cap top. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Measure your vial; set the inner size 2 mm larger. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.