Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Fit a 60-100 mm magnifying lens over the front port, turn the phone image upside down, and lock its rotation; try each slot until the picture is sharp. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Glue two 30 mm, 5x lenses over the eye ports; print stereo pairs 63 mm apart on card and slip them in the back slot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print the sleeve and drawer in contrasting colours; the drawer pushes out from either end. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Print it in black and lay it on a white desk; the faces appear in the white space either side. Prints as shown on its outline, no supports.
Print in yellow PETG for the cheese board. Prints as shown on its outline, no supports.
Cross three or four rubber bands through opposite wall holes to hang the egg in the cradle; tie a carrier-bag parachute to the lid ring. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in blue or black; the corner notch is the write-protect tab. Prints as shown on its floor, no supports.
Print in black or glow-in-the-dark filament; food-safe PETG for the food. Prints as shown on its floor, no supports.
Print the tray pink or red and add black-seed sweets; food-safe PETG. Prints as shown on its floor, no supports.
Print in gold or rose; engrave initials with a marker or a rotary tool on the body. Prints as shown on its outline, no supports.