Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print as many as you like; every tab fits every blank, so they join in any grid. Prints as shown on its outline, no supports.
Put each person's name peg or token in a bay; every Sunday give the turntable a quarter turn. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Agree the fine first; empty it into something nice for everyone. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Food-safe PETG; tilt towards SHAKE for a sprinkle, towards POUR for a spoonful. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Trace one side per four slow counts: in, hold, out, hold. Four laps is about a minute. Prints as shown on its floor, no supports.
Line the bed with a scrap of felt; write the rock's name on masking tape across the lid. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print each step a shade darker; from a high corner it reads as Escher's endless staircase. Prints as shown on its floor, no supports.
Drop a 12 cm nursery pot inside; the ribs keep its sides cooler in full sun. Prints as shown on its floor, no supports.
Write the years on the dividers with a paint pen; the lid keeps the stubs from fading. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Tape a card square to the floor, give it a fast spin and drip runny paint from a squeeze bottle. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.