Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Use four coins each; slide from the notched end, score where they stop, and knock opponents off. Prints as shown on its floor, no supports.
Fill the top tier with gravel, the middle with sand, the bottom with aquarium charcoal on a coffee filter; pour muddy water in and compare. Not for drinking. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
The ring holds cans and cups up to 85 mm; flat base for laps and cushions. Prints as shown on its floor, no supports.
One tasting cup or gaiwan per numbered bay; note scores against the numbers. Prints as shown on its floor, no supports.
Stack the nine whites and nine blacks in the side bays; the queen and striker sit in the centre. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Lay the charging cable through the back port to the glasses' hinge connector. Prints as shown on its floor, no supports.
Give each child a named peg or token; check the board together at the start of the day. Prints as shown on its floor, no supports.
Fill with 1 part sugar to 4 parts water, no dye; clean every 2-3 days. The red text attracts the birds. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
The phone stands inside on its side, filling the screen; the cable leaves through the back. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in clear or smoke grey for the full cassette look. Prints as shown on its floor, no supports. Stacked parts are fused into one print.