Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print face up in white; glue a 10 x 2 mm magnet in the back. Prints as shown on its outline, no supports.
Print in batches; one colour per series. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in the channel colour; scale the holes to your mic handle. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in white with the lid relief in a second colour. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in black or the band's colour. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Sea-glass green translucent PETG looks right. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports.
Print in PETG. Prints flat as a plate, no supports.
Print two. Prints as shown on its outline, no supports.
Print in black. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.