Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Use four coins each; slide from the notched end, score where they stop, and knock opponents off. Prints as shown on its floor, no supports.
Lay the charging cable through the back port to the glasses' hinge connector. Prints as shown on its floor, no supports.
Cut corrugated cardboard into 40 mm strips and stand them on edge, packed tight; flip them when worn. Prints as shown on its floor, no supports.
Print in a dark filament so it warms in the sun; stretch cling film over the rim, hold it with a rubber band and set a pebble right above the centre cup. Prints as shown on its floor, no supports.
Write each name on a lolly stick, stand them in PICK; once a name is picked it moves to DONE until everyone has had a turn. Prints as shown on its floor, no supports.
Write the due date on a card in the label slot; every library book lives here when it isn't being read. Prints as shown on its floor, no supports.
Print in a bold colour; the loops make natural pockets for keys and coins. Prints as shown on its outline, no supports.
Lay coated paper on the floor, leaves on top, then a 2 mm glass sheet on the ledges; expose 10-15 minutes in sun. Prints as shown on its floor, no supports.
The big bay takes most smart-ring charging docks; the cable leaves through the back. Prints as shown on its floor, no supports.
Rest the canvas on the raised inner ring; scrape the cured drips out of the moat and reuse them as paint skins. Prints as shown on its floor, no supports.