Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Keep away from children. Glue the strike strip to the cap top. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Thin walls resonate best: two perimeters, 10 % infill. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Uses the editor lazy-Susan base with BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Battery LED puck only. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print the lid face down for a smooth picture surface. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Body in any colour, lid in clear PETG. Three 8 mm steel balls. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Uses the lazy-Susan ball bearing base. Matt deck colour. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The turntable ring prints separately and runs on 6 mm BBs.
Print in two colours with a filament swap at 30 mm. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the drawer in a contrasting colour. Prints as shown on its floor, no supports. The drawer prints separately from the case. Stacked parts are fused into one print.
Print with 4 walls so the sides are airtight; ease fit to standard if tight. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.