Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Pack safety pins, glue, magnets, Velcro, a mini sewing kit and spare makeup. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Only put tips away cold. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Silicone and glass cups both fit; the bays run from the largest cup to the smallest. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food-safe PETG and hand wash; secure with a strap for travel. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
The tube holds 76 mm felting needles point-down; keep it closed around children. Prints as shown on its floor, no supports. The added base's lid prints separately.
Pack cotton wool with petroleum jelly as tinder; the twist-lock lid keeps it dry. Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Food-safe PETG; the lid turns over into a flat serving board. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Slots fit styluses up to 12 mm thick; the side box takes spare nibs and the nib remover. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Glue the lid down once baited; put it along the ant trail. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fill with natural, untreated wool, cotton or pet fur, never dryer lint or synthetic yarn. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.