Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The long slot takes a 150 mm plexi scraper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
The ring cup fits gourds up to 80 mm across the base. Prints as shown on its floor, no supports. The added base's lid prints separately.
Use the screw lid when travelling; rinse the cup daily. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Slide paper labels into the drawer-front slots. Prints as shown on its floor, no supports. The 4 drawers print separately from the case.
Read the notes together later, then tell your child the monster ate them. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Lay half black and half white paper in each bay, cap gills-down across the join, lid on overnight. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holds six feather or nylon shuttles stacked nose-down. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in black with the lid crack in gold. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
White PETG stays cooler in the car than black. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Keep the lid on between sessions so the slime doesn't dry out. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.