Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print flat; slots are 3.5 mm for 3 mm walls.
Print several in brick red, concrete grey or white. Prints as shown on its floor, no supports.
Print face down; print six or nine for a screen. Prints as shown on its floor, no supports.
Food-safe PETG; light treats only on the upper tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as many storeys as teas; add a fifth eave as the top cap. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Print upright; arches bridge cleanly. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
One block per year, in a new colour each time. Glue in 10 x 3 mm magnets. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a soft pastel; matte PLA shows the engraving. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in dark blue or black so the lit stars stand out. Prints as shown on its floor, no supports.
Print as many rooms as storeys; a dab of museum putty locks the stack. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.