Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Glue 16 x 6 x 3 mm magnets flush, polarity as described. Prints as shown on its floor, no supports.
Twelve 6 x 3 mm magnets. Prints as shown on its floor, no supports.
Print floor down; the floor becomes the back. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print 24 flat in PETG; 36 M3 screws and nylock nuts. Prints flat as a plate, no supports.
Print upright, 4 walls for a stiff stem. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print twelve flat; two M3 bolts. LED lights only. Prints flat as a plate, no supports.
Print four flat in PETG; M4 bolts, nylock nuts, a pencil. Prints flat as a plate, no supports.
Print open side down; 8 mm and 6 mm dowels. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG. Print flat.
Prints in one piece; the pens rest on the desk inside. Print floor-down as shown, then turn it over to use it.