Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print upright in PLA or PETG with no supports. Use 3 walls (perimeters) for a sturdier box. Prints as shown on its floor, no supports.
Print upright in PLA or PETG with no supports. Use PETG if it will sit near a sink or dishwasher. Prints as shown on its floor, no supports.
Print two. Push 6 mm clear tubing into the ports and seal with silicone; a drop of food colouring makes the water easy to see. Prints as shown on its floor, no supports.
Outdoors or well ventilated only (it makes hydrogen). Never use stainless steel plates, never touch the clips while it is on. Prints as shown on its floor, no supports.
Blanks are 20 mm square by 130 mm; write the species on the label strip. Prints as shown on its floor, no supports.
Screw or tape it to the enclosure side; the slot takes scrapers up to 8 mm thick. Prints as shown on its floor, no supports.
The long side slot takes a pencil and a mini spirit level. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holes fit 12 mm toggles, 7 mm rotary encoders and a 22 mm start button; the back port takes a USB-C cable. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
PETG or PP; water-based ink rinses straight off. Prints as shown on its floor, no supports.
Holes fit 9 mm and 13 mm ink caps; wrap in barrier film as usual. Prints as shown on its floor, no supports. Stacked parts are fused into one print.