Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The long side slot takes a pencil and a mini spirit level. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holes fit 12 mm toggles, 7 mm rotary encoders and a 22 mm start button; the back port takes a USB-C cable. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Only put tips away cold. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PLA or PETG; print the lid face down for a flat top. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Fill the race with 6 mm airsoft BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.