Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Opaque matt filament keeps the beam crisp. Print it as shown, then turn it over so the floor becomes the top. The lid is the base; needs a 70 mm LED puck. Print floor-down as shown, then turn it over to use it. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
PETG or ASA outdoors. Fits solar heads 58 to 70 mm wide. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Fits a 6 x 4 inch landscape photo. LED candles only. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flat in PETG; green or terracotta suits most pots.
PETG outdoors; top up the moat after hot days. Prints as shown on its floor, no supports.
Needs a 25 to 35 mm hanging bell and a bamboo skewer. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print standing as shown; the 4 mm wall is solid. Prints as shown on its outline, no supports.
Print as shown (profile on the bed), 100 % infill on the arm. Prints as shown on its outline, no supports.
Deck on the bed. Print it as shown, then turn it over so the floor becomes the top. Needs ball chain and a mirror tile. Print floor-down as shown, then turn it over to use it.
Print standing on one end in translucent PETG, vase-like.