Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG for bathrooms. Prints as shown on its floor, no supports.
Print the lid face down for a smooth picture surface. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Use screws 3 mm longer than the originals. Prints as shown on its floor, no supports.
Print on its end in PETG; jaw fits a 20 mm deep architrave. Prints as shown on its outline, no supports.
Prints as shown on its floor, no supports.
Print many in one colour or a gradient; 15 mm split rings. Prints flat as a plate, no supports.
Runners: two Clasp Rails with a 55 mm wall. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Set the diameter to the bucket base plus 4 mm. Prints as shown on its floor, no supports.
Light colour so the ball shows. Use an 8 mm steel ball. Prints as shown on its outline, no supports.
Body in any colour, lid in clear PETG. Three 8 mm steel balls. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.