Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The tube holds 76 mm felting needles point-down; keep it closed around children. Prints as shown on its floor, no supports. The added base's lid prints separately.
Thread two hook-and-loop straps through the side slots round the rollator seat frame. Prints as shown on its floor, no supports.
Pockets fit standard elongated cents up to 33 x 20 mm; print more trays and stack them. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Hang through the keyholes; each ledge takes about six thimbles. Prints as shown on its floor, no supports.
Pack cotton wool with petroleum jelly as tinder; the twist-lock lid keeps it dry. Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Wire coils sit on their sides in the round cups so they don't tangle. Prints as shown on its floor, no supports.
Print two in TPU or PETG; scale the length to the blade. Prints as shown on its floor, no supports.
Fits 2-inch net cups; float or rest it on a dark tub and top up only once. Prints as shown on its floor, no supports.
Glue the lid down once baited; put it along the ant trail. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fill with natural, untreated wool, cotton or pet fur, never dryer lint or synthetic yarn. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.