Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print face down; back the photos with card and tape. Prints as shown on its floor, no supports.
Print upright; grip feet stop it sliding. Prints as shown on its floor, no supports.
Print flat; slots are 3.5 mm for 3 mm walls.
Print flat; print four to six in contrasting filaments.
Print flat in a light colour.
One block per year, in a new colour each time. Glue in 10 x 3 mm magnets. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Pause at each terrace for a colour change: dark base to white summit. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print two, one for each city, in matching colours. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a soft pastel; matte PLA shows the engraving. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as many rooms as storeys; a dab of museum putty locks the stack. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.