Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Rest the canvas on the raised inner ring; scrape the cured drips out of the moat and reuse them as paint skins. Prints as shown on its floor, no supports.
Glue a sheet of glass or acrylic in the slab bay for the smoothest roll-out. Prints as shown on its floor, no supports.
Print in red or green with the word in gold; envelopes stand in three rows. Prints as shown on its floor, no supports.
Brush both walls with release oil, pour fine concrete into the gap, cure 48 hours, then flex the mould off. Prints as shown on its floor, no supports.
Use LED tea lights, or real ones in metal cups only; print in PETG for warm rooms. Prints as shown on its floor, no supports.
Put a sponge soaked in 1:4 sugar water in some petals and orange slices in others; refresh every two days. Prints as shown on its floor, no supports.
Lay out the primaries at 12, 4 and 8 o'clock and mix the in-between wells. Prints as shown on its floor, no supports.
Hang through the keyholes; each ledge takes about six thimbles. Prints as shown on its floor, no supports.
Print two in TPU or PETG; scale the length to the blade. Prints as shown on its floor, no supports.
PLA or PETG, printed upright. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.