Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in white or dark green. Line with 0.3 mm acetate for a closed case. Prints as shown on its floor, no supports.
Print face down in a sandstone tone; stand it on its long edge. Prints as shown on its floor, no supports.
Print flat in a bright colour. Scale the width with the slot to fit thicker edges.
Print flat; glow-in-the-dark or translucent PETG suits it.
Print face up in white; glue a 10 x 2 mm magnet in the back. Prints as shown on its outline, no supports.
Print in the channel colour; scale the holes to your mic handle. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flat in any colour; hold it to the light.
Print in black or the band's colour. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flat in brass-coloured silk PLA.
Fits 25 x 14 mm full-size lighters. PETG. Prints as shown on its floor, no supports.