Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print upright; PETG. Long screwdriver through the post. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print abacus down; flip to use. Set the socket to your tube. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Felt pads under the plinth protect floors. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Paint the facades before closing; battery LEDs only. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print four or eight; M6 rod, nuts and washers. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Runners: two Clasp Rails with a 55 mm wall. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print several; 3 mm cord and a bead to clamp. Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Print flat; the peg prints upright, a touch of support under the cap. Stacked parts are fused into one print.
PETG or PLA; planks and peg print solid. Prints as shown on its outline, no supports. Stacked parts are fused into one print.