Inro Cap

Close and clamp a stack of carry cells

The top of an Inro stack: a flat plate with matching cord tubes and an engraved ginkgo crest. It closes the highest cell, the cords knot above it, and the sliding bead underneath the knot pulls every layer tight.

Customize this model

Size (Base A): 90 × 50 × 9 mm
Shape: Rectangular
Walls: 4.0 mm
Volume: 21.3 cm³
Est. weight (PLA): 26.4 g
Parts to print: 1
Category: Travel & everyday carry
Made by: Krypto
Built in: 43 steps

What’s in it

Rectangular, 90 × 50 × 9 mm, with 4.0 mm walls
2 holes in the floor
Engraved text: “Label”
2 more bases built on (Bases B–C)
Base B: round, Ø 14 mm, 10 mm tall (beside)
Base C: round, Ø 14 mm, 10 mm tall (beside)

How to print it

Prints flat as a plate, no supports.

Filament: at most about 26.4 g of PLA printed solid (roughly $0.53 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the inro Cap model?

The inro Cap model measures 90 × 50 × 9 mm (width × depth × height). That is Base A; 2 more bases are built on. You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

No. Prints flat as a plate, no supports.

How much filament does it use?

At most about 26.4 g of PLA (21.3 cm³ printed solid), roughly $0.53 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.