Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in the same filament as the base. Prints as shown on its floor, no supports.
Two colours, food-safe PETG. Print it as shown, then turn it over so the floor becomes the top. The cap becomes the base. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
Print four in food-safe PETG; the court takes a 90 mm square bowl. Prints as shown on its outline, no supports.
Print upright as shown, then lay it on the flat face. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food-safe PETG; light treats only on the upper tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as many storeys as teas; add a fifth eave as the top cap. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Print upright; arches bridge cleanly. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print flat in silk gold PLA; picks are food-contact only at the tips.
Print two in food-safe PETG. Prints as shown on its floor, no supports.
Food-safe PETG. Prints as shown on its floor, no supports.