Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print as it comes, open end up; it is a light shell.
Print upright in limestone grey. Prints as shown on its floor, no supports.
Print upright. Prints as shown on its floor, no supports.
PETG; seal inside with a coat of resin for permanent inks. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print it as shown, then turn it over so the floor becomes the top. PETG. Print floor-down as shown, then turn it over to use it.
Arches print bridged; no supports at 0.2 mm layers. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print upright; ledges self-support at 45 degrees. Prints as shown on its floor, no supports.
Line the roof tray before planting live sedum. Prints as shown on its floor, no supports. The 2 drawers print separately from the case. Stacked parts are fused into one print.
Print without supports; 3 perimeters. Prints as shown on its floor, no supports.
Print several in brick red, concrete grey or white. Prints as shown on its floor, no supports.