Models Showcase

Print the bell open side up, as shown; in use the lid is the plate and the bell goes over it. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Food-safe PETG, 3 walls. Cover the centre cup with cling film before screwing the lid on, so no salt water gets in. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Takes flat tins up to 90 mm across (tuna, sardines, cat food). Print upright. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

Food-safe PETG. Put a food-safe silica sachet in CRISP and a slice of bread in CHEWY; swap them every few days. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds. The added base's lid prints separately.

Fits most medium bananas. Print in yellow; PETG for the lunchbox. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.

Print the body and slotted top in clear PETG so the piles show. Swap the labels with paper stickers week by week. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.

They print as two separate pieces. Lay one curve above the other, then swap them over. Prints as shown on its outline, no supports.

Prints flat. The bays are 168, 105, 63, 42 and 21 mm squares. Prints as shown on its floor, no supports.

Prints as one piece with no supports. Tall gear for pens, middle for scissors and rulers, short for clips. Prints as shown on its outline, no supports.

Print the pot and the turntable ring; drop a few ball bearings or a dab of grease between them for a smooth spin. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.