Models Showcase

Stand a 220 x 110 mm sheet of 2-3 mm clear acrylic (or photo-frame glass) diagonally from the front-left to the back-right corner. Use a battery tealight. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down. The added base's lid prints separately.

Print the tower in clear PETG so the beads show; use 8 mm beads. Shake the coins in the front tray; the back foot keeps it steady. Prints as shown on its floor, no supports.

Food-safe PETG. The numbers are engraved in the floors of the bays. Prints as shown on its floor, no supports.

Food-safe PETG. The wells take 46 mm sandwich cookies; lift the ring plate off to wash it. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Print the box and lid; stretch an old sock cuff over each arm hole if you want a curtain. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.

Dampen the table before a race, mark each snail with a dab of washable paint, and return them to where you found them. Prints as shown on its floor, no supports.

Print in clear or translucent PETG so the coins show. Each level prints separately; they stack on rims and lift off to empty. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Print a dozen or more in two colours; flip some over to fill the gaps, as the real tiling does. Prints as shown on its outline, no supports.

Print in two colours with a filament change after the floor so the message stands out. Prints as shown on its floor, no supports.

Line every inside face of the box, and the inside and skirt of the lid, with overlapping copper or aluminium foil tape. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.