Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Check the 6 mm bore holds magnets with light friction. Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Print two per bin in PETG. Prints as shown on its outline, no supports.
Print in pairs. Prints as shown on its outline, no supports.
Print standing on its profile in PETG, 5 walls and 40 % infill.
PETG or nylon; print two, flat on the bed. Prints as shown on its outline, no supports.
Print eight; glue a 10 x 2 mm neodymium disc into each. Prints as shown on its floor, no supports.
PETG; load the base with 6 mm BBs. Print two. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs. Stacked parts are fused into one print.
PETG, 100 % infill. Prints flat as a plate, no supports. Stacked parts are fused into one print.
PETG; print upright with 4 walls. Prints as shown on its floor, no supports.