Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG with 4 walls. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints flat as a plate, no supports.
Translucent white PETG, 1.6 mm walls. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Thread 15 cm of thin cord with an M8 nut as the plumb. Prints flat as a plate, no supports.
Print in bright PETG so it floats into view in a bucket. Prints flat as a plate, no supports.
PETG or ASA; keep it away from the flame. Prints as shown on its outline, no supports.
PETG, 100 % infill. Prints flat as a plate, no supports.
Press in a 608 bearing (22 x 7 mm). Prints as shown on its floor, no supports. Stacked parts are fused into one print.